Rotala H'ra is a Rotala rotundifolia variant that has slightly narrower leaves
Rotala rotundifolia (variants include Rotala colorata, H'ra, Ceylon, etc)
Rotala rotundifola is a fast growing stem plant that has been a staple of the planted aquarium world for a long time. It was first introduced under the erroneous name of Rotala indica around the year 1960, a confusion lasting to this date. The description of real Rotala indica can be found here - along with the explanation of how the names got mixed up.
It is tolerant of wide range of water parameters and is an easy plant to grow ; it does well even in aquariums without carbon dioxide injection after a period of adjustment. However, having sufficient light and CO2 allows it to grow with better density, and better coloration.
As stem plants they grow continually towards the light and will reach the top of even tall aquariums. If allowed to reach the water surface it will breach the surface eventually and grow emersed leaves and flowers. If stems are planted in a tank with high light and with a lot of space surrounding them, they will grown downwards and creep along the substrate. If planted in a more crowded area they will grow vertical more readily. For Rotala Rotundifolia care tips, see below.
KEY SUCCESS FACTORS
HOW TO GET IT REDDER
Rotala Rotundifolia is one of the plants that exhibit redder colors under nitrate limitation - meaning that the plant grows much redder if it is starved for nitrates. Over-do this and the plant will stunt. However, it is much more tolerant of low nitrogen levels than some other plants. When choosing to run low-nitrate levels in a tank, make sure you choose a selection of plants that adapt well to lean dosing conditions. You can read more on lean dosing on this page.
The Seachem nitrate test kit is one that has slightly higher accuracy readings for low NO3 levels for those keen on testing their water.
In this example, you can see clearly the exact point in the plant's growth stage where trimming was done together with nitrate limitation.
Cut a couple of inches off the top of the plant and replant. New shoots will sprout from the inter-nodes on the stem left behind. If initial plant was healthy, you can cut off the majority of the plant, leaving stems a couple of inches in height and new shoots will still sprout from there.
Even if you want a dense bush, plant stems at least half an inch apart to leave room for side-shoots. There should be enough space in the bottom layers even if you want a dense canopy at the higher levels.
Rotala H'ra under Twinstar S series lighting. It takes strong nitrate limitation to induce such deep red colors - NO3 levels would virtually test 0 on test kits.
The same variant Rotala H'ra, when grown without nitrate limitation.
Rotala rotundifolia 'red' in my own tank with NO3 levels measuring less than 3ppm or so. Enough to induce significant redness but not so much as to stunt other more demanding plants in the same tank.
Rotala rotundifolia green and red are used in the middle of this layout from ADA gallery niigata. Due to the lean dosing ADA schedule, this plant is especially suitable for such tanks.
Rotala rotundifolia takes trimming well and will form dense bushes. It can be repeatedly trimmed for many cycles before requiring replanting of healthier/new tops. This makes it very useful for aquascaping where the ridge line needs to be kept at a certain height for aquascaping purposes.
Trimming should be done initially about 4 inches below the final height that you want your Rotala rotundifolia tops to be at. (unless you have planted your Rotala rotundifolia very sparsely to start with, then trimming further down allows more branching and density to build up) As the tops grow out, cut off the ones that grow faster than the rest - this allows the shoots below to branch and the canopy to gain density as it grows upwards.
After the canopy has been formed at the desired height, you should continually thin it by cutting off the tallest shoots and allowing new growth to take its place. This needs to be done very regularly (every 3 days or so). If the canopy rises as a whole after a long period of lack of trimming, then you have to do a reset as above; cutting the bush down much lower and growing out the tops again. As with carpets - if you want to maintain it long term, it requires very frequent trimming. Growing the tank under lean conditions also slows down plant growth as a whole and reduces pruning.
Over a long time (months), the older undergrowth will deteriorate to a point where it is unhealthy. You should then allow the top to grow out longer, then replant the bush as a whole.